This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 87/308 EEC of 02/06/87 (Radio Interference
Suppression Directive) and subsequent
modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Before carrying out any work, remove the plug from
the power socket.
Grid preparation
Remove the grid from the appliance pulling it towards
you with hands.
Right door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure, a).
Left door opening:
Remove the right side (B) of the grid cutting it from the
rear (see figure, b).
To reposition the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by pushing
the clasps (a) until they click.
N.B. The grid is to be assembled after having fixed the
appliance in the niche with the brackets.
Door reversal
The appliance must be unplugged before starting
work. To reverse the opening direction of the door,
proceed as follows:
1. remove the top hinge (1) taking care not to let the
door fall;
2. remove the bottom door hinge (2).
3. take out the plugs (3) from the holes (F) and
reinsert them in the holes (F
1
) on the opposite side;
4. refit the upper hinge (1) on the opposite side, on the
bottom (position A);
5. refit the door on the pin of the hinge (1) in position
A;
6. insert the pin of the unscrewed bottom hinge (2) in
the upper hole (G) of the door, therefore fix the
hinge on the top in position B.
Important
After completion of the door reversal operation,
verify that the door gasket is sealing onto the
cabinet. If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit perfectly to the
BUILDING-IN INSTRUCTIONS
S.I.003
F
F
B
A
F
3
1
2
G
1
F1
S.I.002
A
B
a
b
S.I.001
a
a
cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this
process by heating up the part involved with
a normal hairdryer on a low setting.
t
21
