Zanussi ZSLN1211, Руководство пользователя

Страница: 11 / 20

3. Remove the spilled rinse aid with an absorbent
cloth to prevent excessive foam formation.
4. Close the lid. Make sure that the lid locks into
position.
DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in programme
selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for the
type of load and the degree of soil.
USING THE DETERGENT
B
C
A
CAUTION! Only use detergent
designed specifically for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent in the compartment (A). You
can use detergent in tablets, powder or gel.
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the lid locks into
position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a
load with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.
SETTING AND STARTING A PROGRAMME
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance is in
programme selection mode.
3. Press the programme button repeatedly until
the indicator of the programme you want to
select starts flashing.
4. Close the appliance door to start the
programme.
Starting a programme with delay start
1. Set a programme.
2. Press the delay button to delay the start of the
programme by 3 hours.
The indicator is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to change
the programme.
When the countdown is complete, the programme
starts.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it as this may
cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running
programme ends.
11