Zanussi ZRT18101WA, Руководство пользователя

Страница: 33 / 40

1. Deactivate the appliance.
2. Remove all the food from the freezer. Wrap
the food in newspaper and keep it at a
cold temperature.
3. Keep the appliance door open until de-
frosting is completed.
4. Clean and fully dry the freezer.
5. Connect the mains plug to the mains sock-
et.
6. Activate the appliance.
7. Set the temperature knob at the highest
position and let the appliance operate for 2
or 3 hours with this setting.
8. Put back the food in the freezer.
When the appliance is not used for long
periods
1. Deactivate the appliance and disconnect
the mains plug from the mains socket.
2. Remove all the food.
3. Defrost the appliance.
4. Fully clean and dry the appliance and all
the accessories.
5. Keep the doors open to prevent unpleas-
ant smells.
Replacing the lamp
1. Disconnect the mains plug from the mains
socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover
4. Replace the old lamp with a new one. Use
only lamps for household appliances. The
lamp cover shows the maximum power of
the lamp.
5. Install again the lamp cover.
6. Connect the mains plug to the mains
socket.
The type of light bulb or halogen lamp
used for this appliance, is only for house-
hold appliances. Do not use it for house light-
ning.
Troubleshooting
Warning! Disconnect the mains plug
from the mains socket before you do the
check.
For problems that are not in the table, contact
the Service.
Problem Possible solution
The appliance makes noise during
operation. Some sounds are normal when the appliance is operating. Refer to
the leaflet supplied with the appliance.
The appliance does not operate. Make sure that the appliance is activated.
Make sure that the mains plug is connected to the mains socket.
Do a check and see if there is voltage. Connect a different appliance
to the same mains socket. To repair a mains socket, contact a quali-
fied electrician.
The lamp does not come on. Close and open the door to make sure that the lamp is not in stand-
by.
The lamp is defective. Replace the lamp.
The compressor operates continu-
ously. Set the temperature knob at a lower position.
33
www.zanussi.com