Zanussi ZRB227WO, Руководство пользователя

Страница: 8 / 14

8
Electrical connection
The appliance should be level in order to elim-
inate vibration. To make the appliance level ,it
should be upright and both adjusters should be
firmly contacted with the floor. You can also
adjust the level by screwing out the appropriate
level adjuster at the front (use your fingers or
a suitable spanner).
Levelling
Climate class
Ambient temperature
SN
N
ST
T
o o
+10 C to +32 C
o o
+16 C to +32 C
o o
+16 C to +38 C
o o
+16 C to +43 C
The appliance should be installed well away
from sources of heat such as radiators ,boilers ,
direct sunlight etc. Ensure that air can circul-
ate freely around the back of the cabinet. To
ensure best performance ,if the appliance is
positioned below an overhanging wall unit ,the
minimum distance between the top of the cabi-
net and the wall unit must be at least 100 mm.
Ideally ,however ,the appliance should not be
positioned below overhanging wall units. Accu-
rate leveling is ensured by one or more adjust-
able feet at the base of the cabinet.
Location
Warning !
It must be possible to disconnect
the appliance from the mains power suppl-
y; the plug must therefore be easily acce-
ssible after installation.
Any electrical work required to
install this appliance should be carried
out by a qualified electrician or competent
person.
Warning !
This appliance must be earthed.
The manufacture declines any liability
should these safety measures not be
observed.
Caution !
1
2
3
4
5
The wires in the mains lead are
colored in accordance with the following code:
Important !
1 Green and Yellow :
3 Brown : Live
5
Blue :
Earth
Neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug ,proceed as follows:
1. Connect the wire coloured green and yellow
to the terminal marked either with the letter
“ E ” or by the earth symbol or coloured
green and yellow.
2. Connect the wire coloured blue to the termi-
nal either marked with the letter “ N ” or col-
oured black.
3. Connect the wire coloured brown to the ter-
minal either marked with the “ L ” or colour-
ed red.
4. Check that no cut ,or stray strands of wire is
present and the cord clamp is secure
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
fitted . In the event of having to change the
fuse in the plug supplied ,a 13 amp ASTA
approved (BS 1362) fuse must be used.
4
2
Warning ! A cut off plug inserted into a 13
amp socket is a serious safety (shock) ha-
zard. Ensure that it is disposed of safety.
Door reversibility
The side at which the door opens can be
changed from the
left
side ( as supplied) to
the
right
side ,if the installation site requires.
Before you start lay the refrigerator on its back
in order to gain access to the base ,you should
rest it on soft foam or similar material to avoid
damaging the cooling pi pes at the rear of refri-
gerator.
1. Stand the refrigerator ,use a flat bladed
screw driver to remove the 4 screw covers
in the refrigerator lid.