Zanussi ZRA40100WA, Руководство пользователя

Страница: 8 / 16

Problem Possible cause Solution
Products prevent that water flows
into the water collector. Make sure that products do not
touch the rear plate.
Water flows on the ground. The melting water outlet does not
flow in the evaporative tray above
the compressor. Attach the melting water outlet to the
evaporative tray.
The temperature in the ap-
pliance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the ap-
pliance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time. Store less products at the same
time.
There is no cold air circulation in
the appliance. Make sure that there is cold air circu-
lation in the appliance.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.
1 2
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height 1850 mm
Width 600 mm
Depth 660 mm
Voltage 230 - 240 V
Frequency 50 Hz
8
www.zanussi.com