36
INSTALLATION
GB
If this appliance featuring magnetic door
seals is to replace an older appliance having a
spring lock (latch) on the door or lid, be sure
to make that spring lock unusable before you
discard the old appliance. This will prevent it
from becoming a death-trap for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Best performance is obtained with
ambient temperature b18°C and +43°C
(class T); +18°C and +38°C (class ST); +16°C
and +32°C (class N); +10°C and +32°C (class
SN). The class of your appliance is shown on
its rating plate.
For building into kitchen units follow the special “
Building-in” instructions given.
Important
It is essential that the appliance be connected to
an efficient earth tap. For this purpose the supply
cable plug incorporates a special earth contact. If
the sockets of your domestic wiring system are
not earthed, have the appliance connected to a
separate earth wire by a qualified electrician in
accordance with existing safety regulations.
The Manufacturer declines all responsibility
if the above safety precautions are not
observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent mod)fications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap so
as to remove the typical smell of a brand-new
product, then dry thoroughly. Do not use
detergents or abrasive powders, as these will
damage the finish.
Assembly instructions
Fitting the decor panel
(Fig. 1)
Preliminary requirement: the overall dimensions
of the decor panel must be 1-2 mm less than
those of the door, with a maximum thickness of
4 mm. With the refrigerator door closed,
unscrew the screws securing the removable
side piece of the frame to the door. Remove this
side piece and slide the decor panel into place,
after having slackened the remaining frame
screws; push the panel fully home and secure
the frame to the door, including the side piece
previously removed.
Fig. 1
