Zanussi ZOB 985 QP, Инструкция по эксплуатации

Страница: 16 / 25

79
Fig. 22
Fig. 23
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Power: 40 W,
- Voltage: 230 V (50 Hz),
- Temperature Rating of 300 °C,
- Thread type: E14.
These bulbs are available from your local Service Force
Centre.
To replace the faulty bulb (Fig. 23):
1. Ensure the oven is disconnected from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
To programme the pyrolytic
cleaning cycle (delayed start,
automatic stop)
If you desire, you can programme the starting and end-
ing time of the pyrolytic cleaning cycle.
1. Press button to switch on the oven. Press the
button as often as necessary, until the “Pyro“
function symbol (level 1 - P I) appears in the
display.
2. The Cooking Duration symbol will flash for some
seconds; during this time push ' ' or ' ' buttons to
select the pyrolytic 1 (P I) or pyrolytic 2 (P 2) func-
tion.
3. Once you have chosen the desired pyrolytic func-
tion, “Pyro” will flash in the display waiting for confir-
mation to start the pyro cleaning function.
At this time, push the time function button
(Fig. 22). The "End of Cooking" symbol
and
the arrow symbol will flash. The control panel
will display the end of the cleaning cycle (that is,
the actual time + cooking duration time).
Push ' ' or ' ' buttons to select the required end of
cycle time (Fig. 22). Then, the “Pyro” writing stops
flashing, the oven lamp switches off and the pyrolytic
cleaning cycle starts at the set time.
4. After some time, the door lock will be activated and
the related symbol will be displayed.
At the end of the pyrolitic cleaning process, the display
shows the time of day. The oven door is locked.
Once the oven has cooled down, an acoustic signal will
be emitted and the door will unlock.
To stop the pyrolytic cleaning cycle at any time, press
button
.