Zanussi ZNLK18ES3, Руководство пользователя

Страница: 17 / 24

Problem Possible cause Solution
Temperature is set incorrectly. Refer to "Control panel" chapter.
Appliance is fully loaded and is set
to the lowest temperature.
Set a higher temperature. Refer to
"Control panel" chapter.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
Set a higher temperature. Refer to
"Control panel" chapter.
Water flows on the rear plate of the
refrigerator.
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
There is too much condensed water
on the rear wall of the refrigerator.
Door was opened too frequently. Open the door only when necessa‐
ry.
Door was not closed completely. Make sure the door is closed com‐
pletely.
Stored food was not wrapped. Wrap food in suitable packaging be‐
fore storing it in the appliance.
Water flows inside the refrigerator. Food products prevent the water
from flowing into the water collector.
Make sure that food products do not
touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set. The FastFreeze function is switched
on.
Switch off FastFreeze function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "FastFreeze func‐
tion" section.
The temperature in the appliance is
too low/too high.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door" section.
The food products' temperature is
too high.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Many food products are stored at
the same time.
Store less food products at the
same time.
The thickness of the frost is greater
than 4-5 mm.
Defrost the appliance.
The door has been opened often. Open the door only if necessary.
The FastFreeze function is switched
on.
Refer to "FastFreeze function" sec‐
tion.
There is no cold air circulation in the
appliance.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
ENGLISH 17