Problem
Possible cause
Solution
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
The compressor starts after a
period of time.
This is normal, no error has oc-
curred.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled.
Refer to installation instruc-
tions.
Door does not open easily.
You attempted to re-open the
door immediately after closing.
Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work.
The lamp is in stand-by mode.
Close and open the door.
The lamp is defective.
Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly.
Refer to "Control Panel" chap-
ter.
Appliance is fully loaded and is
set to the lowest temperature.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct.
There is too much condensed
water on the rear wall of the re-
frigerator.
Door was opened too fre-
quently.
Open the door only when nec-
essary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrapped.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Water flows inside the refriger-
ator.
Food products prevent the wa-
ter from flowing into the water
collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clogged.
Clean the water outlet.
14
Содержание ZNHN18FS1
Страница 52: ...WWW ZANUSSI COM SHOP 222378913 A 492020 ...