Zanussi ZL714W, Инструкция пользователя

Страница: 16 / 20

16
Zanussi 818 14 54-05/2
Door Reversal
1. Close the cabinet and remove the plug from the
electrical socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Reposition it and
transfer to the opposite side.
3. Support the cabinet on a wooden block when it is
laid down. This will make it easier to grip under the
cabinet when returning to an upright position.
4. On the upper part of the cabinet. Remove the
hinge pin and replace on the other side.
5. On the lower part of the cabinet. Unscrew the
hinge. Move the hinge pin and plastic cover. Secure
the hinge on the other side.
6. Raise the cabinet and replace the ventilation grille.
7. Unscrew the handle. Carefully press in the plastic
plugs on the opposite side using a punch. Secure the
handle in the plug holes. Then press the supplied
plastic plugs into the holes to which the handle was
previously fitted.
8. Put the cabinet in position. Check that it stands
straight. See the section "Positioning the cabinet".
Attention
After completion of the door reversing
operation, check that the door gasket adheres
to the cabinet. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate
this process by heating up the part involved
with a normal hairdryer on a low setting.
1
2
3
4
5
7