Zanussi ZKN7147J, Руководство пользователя

Страница: 19 / 32

2. Switch the machine on by turning the se-
lector dial to the set washing programme/
fabric.
3. Select the required options by pressing the
relevant buttons.
If possible, do not select a spin
speed lower than that proposed by
the appliance to avoid too long a drying
time therefore saving energy.
In any case the reduction of the spin speed
is only possible after selecting drying.
The lowest values you can select are 900
r.p.m. for cottons and synthetics and 700
r.p.m. for delicate fabrics.
4. Set the drying time by pressing button 4 .
The display shows the whole duration of
the washing and the set drying cycle.
If you set a washing programme and only
10 minutes of drying cycle, the total dura-
tion displayed includes also the unrolling and
the cooling phase.
5. Start the programme by pressing button 7 .
The time remaining is updated every minute
on the display.
6. At the end of the programme turn the se-
lector dial to the
position to switch the
machine off and remove the laundry.
Fluff in the fabrics
During the WASHING AND/OR DRYING
PHASE, certain types of fabric, such as
sponge, wool, sweatshirt, could release fluff.
The released fluff could stick to the fabrics dur-
ing the next cycle.
This drawback increases with technical fabrics.
To prevent the fluff in your clothes, it is
recommended
:
• To do not wash dark fabrics after you wash-
ed and dried light colored fabrics (new
sponge, wool, sweatshirt especially) and vice
versa.
• To air-dry this type of fabrics when they are
washed the first time.
• To clean the drain filter.
• After the drying phase, thoroughly clean the
empty drum, the gasket and the door with a
wet rag.
To remove the fluff inside the drum, run a
special programme to clean it
:
• Empty the drum and clean the drum, the gas-
ket and the door with a wet rag.
• Turn the programme selector to the rinse
programme.
• Activate the cleaning function by pressing at
the same time button 5 and button 8 until the
display shows CLE .
• Press button 7 to start the programme.
Care and cleaning
Warning! You must DISCONNECT the
appliance from the electricity supply,
before you can carry out any cleaning or
maintenance work.
Descaling
The water we use normally contains lime. It is a
good idea to periodically use a water softening
powder in the machine. Do this separately from
any laundry washing, and according to the soft-
ening powder manufacturer's instructions. This
will help to prevent the formation of lime depos-
its.
External cleaning
Clean the exterior cabinet of the appliance with
soap and water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser
drawer should be cleaned regularly.
19
www.zanussi.com