Zanussi ZKN 7147 J, Руководство пользователя

Страница: 29 / 32

If your drain hose
looks like this (see
beside) you do not
require the “U”
piece”. Just push the
hose firmly in to the
standpipe.
2. Onto a sink outlet spigot.
Loop
If the outlet spigot
has not been used
before, remove any
blanking plug that
may be in place. Push the drain hose
onto the spigot and
secure with a clip,
ensure a loop is
formed in the drain
hose (see above) to
prevent waste from
the sink entering the
appliance.
If you intend to drain the hose from the ma-
chine into a sink, make sure that the sink is
empty and the plug hole is not blocked. Use
the plastic “U - Piece” supplied.
Special conditions
If the floor is carpeted or covered with crumbly
or soft material, insert a rigid support base un-
der the feet to prevent noise, vibration or dis-
placement. The base should protrude a few
centimetres beyond the edges of the appliance.
Warning! The appliance should NOT be
placed on deep pile carpeting.
Note!
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
In the interest of the environment
The appliance should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river.
It is essential that these appliances are not con-
nected to the surface water drainage system as
this water is discharged directly into a river or
stream and may cause pollution.
If you require any further advice please contact
your local water authority.
SHOWER
WASHING
MACHINE
DISHWASHER
BATH
SINK TOILET
BIDET
RAINWATER
‘RUN-OFF’
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER RIVER
TREATED DISCHARGE
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
Electrical connection
Any electrical work required to install this appli-
ance should be carried out by a qualified elec-
trician or competent person.
Warning! THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance’s rating plate.
Warning! Information on the
electrical connection is given on the
rating plate on the inner edge of the
appliance door.
The appliance is supplied with a 13 amp plug
fitted.
29
www.zanussi.com