Zanussi ZI 8 FF, Инструкция пользователя

Страница: 16 / 20

5
OPERATION
Before using
Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Setting the temperature
The temperature inside the refrigerator and the
freezer is regulated by a single thermostat with 6
temperature positions and an “OFF” (O) position.
Position 1 = minimum coldness
Position 6 = maximum coldness
Turn the thermostat dial to the required position.
The intermediate position is usually the most
suitable (3-4).
The thermostat setting can vary as the temperature
inside the refrigeration compartment depends on the
following factors:
– room temperature
– how often the door is opened
– how much food is stored
– position of the appliance
Important
During prolonged periods of abnormally hot weather,
if the thermostat is set on too high a number, the
cooling system may operate continuously and the
fridge cooling plate may not defrost. Turning the
knob to a lower number will cause the automatic
defrosting to resume.
Low Ambient Temperature Switch
To ensure that the appliance is working efficiently
when the room temperature drops below 16°C, the
switch mounted next to the thermostat control should
be switched on.
No damage can be caused by leaving the switch in
this position for any period of time (see page 10 Low
ambient operation). However should the temperature
rise above 16°C remember to turn the switch off
again.
The freezer compartment
The four-star freezer compartment is suitable for
storage of commercially frozen food and for freezing
fresh foods.
Freezing fresh food
When freezing large amount of fresh food turn the
thermostat control knob maximum approximately 1
hour prior to freezing. When the food is frozen return
thermostat control knob to normal position.
In any 24 hours you can freeze up to 3.5 kg. of fresh
food.
Place food to be frozen in the upper drawer of the
freezer as this is the coldest part.
To guarantee a good operation of the appliance
during normal use, the drawers should not be
removed.
A - Low Ambient Switch
D710
A
Frozen food storage
When you first start the freezer or if the freezer has
been out of use for some time, we advise you to
depress the ambient switch for at least two hours
before storing frozen food.
Do not exceed the storage period indicated by the
manufacturer.
Finally, do not open the door frequently or leave it
open longer than is absolutely necessary.
16
Furthermore, it is necessary that the cabinet has a
ventilation recess with the following dimensions:
depth 50
mm
width 540 mm
Instructions for totally built-in
appliances
Door reversal
Recess dimensions
Height (1) 1780 mm
Depth (2) 550 mm
Width (3) 560 mm
To ensure adequate ventilation, allow the clearances
shown in figure.
50 mm
min.
200 cm
2
200 cm
2
min.
D567
B
C
A
The appliance is supplied with the door
hinges on the right or on the left. To
change the opening direction of the doors
proceed as follows before installing the
appliance.
1. Gently lay the appliance on its back with the top
held away from the floor by 5-8 cm (2-3 inches) of
packaging;
2 Unscrew the upper pin and remove the spacer
3. Remove the upper door
4. Unscrew the pins (B) and the spacers (C) and
refit them on the middle hinge of the opposite
side. Snap the hinge cover (A).
5. Refit the upper door, the upper pin and the
spacer on the opposite side
6. Unscrew the lower pin and remove the spacer
and refit them on the opposite side
PR01
540
50
3
2
1