11
Fig. 9
FO 0288
The Oven Door and its gasket
Before cleaning the oven door, we recommend you to
remove it from the oven.Proceed as follows:
a) open the oven door completely;
b) find the hinges linking the door to the oven (fig. 9);
c) unlock and turn the small levers located on the two
hinges (fig. 9);
d) handle the door by its left- and right-hand sides, then
slowly turn it towards the oven until it is half-closed;
e) gently pull the oven door off its site (fig. 9);
f) place it on a steady plan.
Clean the oven door glass with warm water and a softh
cloth only. Once the cleaning is carried out, refit the oven
door, following the procedure in reverse.
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
Periodically
check
the condition of this gasket. If
necessary, clean it without using abrasive cleaning
products.
If the gasket shows to be
damaged
, call you local
Service Centre. Do not use the oven until it has been
repaired.
Replacing the Oven Light
Ensure the electricity supply is switched off
before carrying out this operation.
The oven bulb has to comply to these features:a) resistant
to temperatures of 300 °C; b) electric rate: 230 V - 50
Hz; c) electric power rate: 25 W; d) connection type: E
14.
To replace the bulb, proceed as follows (Fig. 10):
a)
push in and turn the glass lid anticlockwise;
b)
remove tha faulty bulb;
c)
replace it with a new one;
d)
refit the glass lid;
e)
switch on the electricity supply.
The Hinged Grill
Some models are fitted with a hinged grill element, to
enable you to clean the roof of the oven easily.
Before proceeding ensure the oven is cool
and is isolated from the electricity supply.
l
Undo the screws which hold the grill in place (see
Fig. 11). When doing this operation for the first time,
we recommend using a screwdriver.
l
Then gently pull the grill downward to allow access to
the oven roof.
l
Clean the oven roof with a suitable cleaner and wipe
dry before replacing the hinged grill element.
l
Gently push up the grill element into place and firmly
screw into place the holding nuts.
Ensure the grill holding nuts are firmly in
place to avoid the grill falling down when in
use.
Grease Filter
When cooking meat, the grease filter must be fitted over
the oven fan by clipping it over the vents in the back
panel. This will prevent a built-up of fat on the fan
impellor. Do not use abrasive materials to clean the seal.
The grease filter is dishwasher proof.When cooking is
completed and the oven has cooled down, remove the
filter by pushing the protruding tongue on the filter
upward (Fig.12) Wash the filter after use using warm
soapy water.
Fit the grease filter only when roasting.
FO 0018
Fig. 12
Fig. 11
FO 0287
Fig. 10
