18
Door reversal directions
Before starting work, unplug the appliance. To reverse
the opening direction of the door proceed as follows:
Remove the lower hinge (3), the pin (1), the washer
(4) and the screw (2);
slide the door out from the pin (5), remove the pin and
place it on the opposite side;
unscrew the foot front left and place it on the opposite
side;
unscrew the two screws which mask the holes for
fixing the hinge on the front left side;
reassemble the door;
refit the lower hinge (turning it 180
°
), the washer, the
pin and the screw on the opposite side, as shown in
the figure.
remove the handle, after having removed the screw
cover and refit it on the opposite side.
The holes that are not used must be masked with the
plastic plugs removed.
Attention
After completion of the door reversibility operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part involved
with a normal hairdrier.
Fitting the door panel
(for models equipped with door frame)
To fit the door panel, proceed as follows:
– remove the fixing screws and remove the frame
side opposite the handle;
– loosen, without removing them, all remaining
screws fixing the door frame;
– insert the panel from the side on which the frame
has been removed and push it fully in;
– refit the frame side and tighten all the screws.
Note
The panel size should be 1-2 mm smaller than the
door; the maximum permissible panel thickness is
4 mm.
Fig. 3
Fig. 3a
Fig. 3b
5
D548
180°
1
3
2
D299
2
D162
