11
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock on the
door or lid, be sure to make that spring lock unusable
before you discard the old appliance. This will prevent
it from becoming a death-trap for a child.
Location
Place the appliance as far away as possible from
sources of heat, e.g. radiators, heaters, direct
sunlight, etc..
The best results are achieved with a room
temperature ranging from +18
°
C to +38
°
C (class
ST) or from +18
°
C to +43
°
C (class T). The class of
your appliance is shown on its rating plate.
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For more efficient operation of the appliance the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any,
should be at least 100 mm (Fig. 1-A).
The best solution is shown in Fig. 1-B (without
overhanging kitchen furniture).
The appliance sides may also be in contact with the
kitchen furniture, provided that air can circulate
freely round the back and top.
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly
level.
Fig. 1
Rear spacers
In the plastic envelope containing the Operating
Instructions are also included two wall spacers to be
fitted into the special openings provided on the back
of the appliance (Fig. 2).
Push-fit the spacers into the openings, making sure
that arrow (A) is positioned as per Fig. 2 and then
turn the spacers through 45
°
until they lock in
(arrow in vertical position).
A
B
D194
100 mm min.
Fig. 2
Power connection
Before plugging the appliance into the mains
socket, check that the voltage and frequency
indicated on the appliance’s rating plate are the
same as those provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable.
Make sure the plug and the socket are compatible so
that no adaptors need to be used. If necessary,
replace the socket with a suitable one.
The appliance MUST be connected to an efficient
earth or ground tap.
The supply-lead plug in fact incorporates a special
earth or ground contact for this purpose. If by any
chance the sockets of your domestic wiring system
are not earthed, the appliance must be connected to
a separate earth or ground wire by a qualified
electrician, in accordance with existing safety
regulations.
The manufacturer declines to accept any liability if
this accident-prevention procedure is not followed.
This appliance complies with the relevant UNI
standards and with E.E.C. Directive No. 87/308 of
02.06.87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
D060
A
45°
