Zanussi ZEM6740FBA, Руководство пользователя

Страница: 12 / 20

Problem Possible Remedy
The residual heat indicator does
not come on. The cooking zone is not hot be-
cause it operated only for a short
time. If the cooking zone operated suf-
ficiently long to be hot, speak to
the service centre.
The Automatic Heat Up function
does not operate. The cooking zone is hot. Let the cooking zone become
sufficiently cool.
The highest heat setting is set. The highest heat setting has the
same power as the Automatic
Heat Up function.
The heat setting changes be-
tween two levels. The Power management is activa-
ted. Refer to “Power management”.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls. Put large cookware on the rear
cooking zones if necessary.
comes on
The Automatic Switch Off oper-
ates. Deactivate the appliance and ac-
tivate it again.
comes on
The Child Safety Device or the
Lock function operates. Refer to the chapter “Daily Use”.
comes on
No cookware is on the cooking
zone. Put cookware on the cooking
zone.
Incorrect cookware. Use the correct cookware.
The diameter of the bottom of the
cookware is too small for the
cooking zone. Move cookware to a smaller
cooking zone.
and number comes on.
There is an error in the appliance. Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
comes on
There is an error in the appliance
because a cookware boils dry.
The overheating protection for the
cooking zones and the Automatic
Switch Off operate. Deactivate the appliance. Re-
move the hot cookware. After ap-
proximately 30 seconds, activate
the cooking zone again. If the
cookware was the problem, the
error message goes out of the
display, but the residual heat indi-
cator can stay. Let the cookware
become sufficiently cool and refer
to “Cookware for the induction
cooking zone” to see if your
cookware is compatible with the
appliance.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rat-
ing plate, three digit letter code for the glass ceramic (it is in the corner of the glass sur-
face) and an error message that comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer serv-
12
www.zanussi.com