Zanussi ZEAN11FW0, Руководство пользователя

Страница: 16 / 20

Problem Possible cause Solution
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The Super Freeze function is
switched on.
Switch off the Super Freeze
function manually, or wait until
the function deactivates auto-
matically to set the tempera-
ture. Refer to "Super Freeze
function" section.
The temperature in the appli-
ance is too low/too high.
The temperature is not set cor-
rectly.
Set a higher/lower tempera-
ture.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The food products' tempera-
ture is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened of-
ten.
Open the door only if necessa-
ry.
The Super Freeze function is
switched on.
Refer to "Super Freeze func-
tion" section.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
REPLACING THE LAMP
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation" chapter.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
16