1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light comes on.
3. Check that there is rinse aid and salt
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely
6. Measure out detergent
Add the required amount of detergent according to the
dosage quantity given in the "Washing programmes"
chart.
Close the detergent dispenser lid.
7. Set the programme
The selection of the programme occurs with the open
door.
Press the programme push button which corresponds to
the washing programme you wish to select, the
corresponding indicator light will flash.
If you want to change washing programme, simply press
another programme push button.
8. Start the programme
Close the door.
An audible signal advises you that the programme has
started.
The indicator light which corresponds to the programme
under way is now permanently on.
9. At the end of the washing
programme
The dishwasher will automatically stop and an audible
signal informs you that the programme has ended.
The "end of cycle" indicator light flashes.
The On/Off indicator light remains on until the On/Off
push button is depressed.
Wait until the end of the audible signal before opening
the door.
10. Switch off the dishwasher
Open the door and switch off the dishwasher by
pressing the On/Off push button.
Wait a few minutes before removing the dishes; in this
way they will be cooler and the drying will be improved
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
11. Cancel a programme
To change a programme in progress, open the door and
press the push button of the programme under way for
more then 1 second, until the corresponding indicator
light goes out.
The dishwasher is now reset and you can select a new
programme.
Important!
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
steam may escape.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
4
Operating sequence
