Zanussi ZDT 6053, Инструкция

Страница: 13 / 24

In this fully integrated appliance the controls are located on the
top of the door. When selecting a washing programme, the
door needs to be slightly open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Setting and starting the washing
programme
Press the On/Off button.
The END OF CYCLE indicator light flashes.
Press the programme selection/cancel button and select
the desired washing programme. To choose the right
washing programme see "Washing programmes" chart).
Close the dishwasher’s door, the programme will start
automatically.
NOTE: the start of the washing programme will occur only
after the closure of the door. Until that moment you can
modify the selection made.
4. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
Open the dishwasher’s door; the programme will stop.
Close the door; the programme will start from the
point at which it was interrupted.
To cancel a washing programme in progress
Open the dishwasher’s door. Press the programme
selection/cancel button for about 3 seconds, until the
indicator light of the running programme turns off and the
END OF CYCLE indicator light flashes, indicating that
the running programme has been cancelled and that the
machine has returned to setting mode.
It is now possible to select another washing programme.
If a new washing programme will be selected, check that
there is detergent in the detergent dispenser.
NOTE: only during the drying phase, if the dishwasher’s
door will be opened and remains open for more then 30
seconds, the running programme will be automatically
cancelled and the machine will return to setting mode.
This will happen, always only during the drying phase,
also when the machine is switched off by pressing the
On/Off button and remains switched off for more then 30
seconds.
5. End of the washing programme
The dishwasher will automatically stop. An audible signal
informs you of the end of the washing programme.
Open the dishwasher’s door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
be cooler and the drying will be improved.
The END OF CYCLE indicator light is on.
The indicator light of the programme just ended is on.
Switch off the dishwasher by pressing the On/Off button.
6. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme
13