28
Installation Instructions
General
Any electrical work required to install this ap-
pliance should be carried out by a qualified
electrician or competent person.
Any plumbing work required to install this ap-
pliance should be carried out by a qualified
plumber or competent person.
-
The dishwasher is delivered ready for connection,
i.e. with power supply cable, drain hose and inlet
hose with fitted filter and seal.
-
The installation should be carried out to connec-
tions provided in a neighboring cupboard (not di-
rectly behind the unit).
-
The regulations of the local water and electricity
companies must be complied with.
Do not dismantle the unit! The installed water-
softener contains water, which can escape.
Water supply connec−
tion
-
The unit must be connected to a cold water supply.
-
The water pressure must be within the limits given
in the technical specifications (1 to 10 bar running
water pressure). Your local Water Authority will ad-
vise you on the average mains pressure in your
area.
-
A shut-off device with a
¾
” connection must be
provided on site.
-
The inlet hose has a filter to remove any impurities
from the water supply and a rubber seal. When fit-
ting ensure that the filter and seal are correctly po-
sitioned
.
No water must escape from the fitting after the
shut-of f device has been opened.
Do not use, for connection, old hoses which
have been used in another appliance.
Water outlet hose con−
nection
-
Ensure the drain hose is not bent or squashed as
the could prevent or slow down the discharge of
water.
-
The outlet hose should be connected to a water
outlet provided in a neighboring cupboard (not di-
rectly behind the unit).
-
The dishwasher is fitted with a device to prevent
the back flow of water, which allows the installation
height of the unit to be above the outlet height.
-
The highest point of the drain hose should never
exceed the unit height.
86 - 91 cm
