Zanussi ZDSN653X1, Руководство пользователя

Страница: 17 / 24

TROUBLESHOOTING
WARNING! Improper repair of the
appliance may pose a danger to the
safety of the user. Any repairs must be
performed by qualified personnel.
The majority of problems that may occur can
be solved without the need to contact an
Authorised Service Centre.
Refer to the below table for information on possible
problems.
With some problems, the display shows an alarm
code.
Problem and alarm code Possible cause and solution
You cannot activate the appli-
ance.
• Make sure that the mains plug is connected to the mains sock-
et.
• Make sure that there is no damaged fuse in the fuse box.
The programme does not start. • Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end of
the countdown.
• The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
The appliance does not fill with
water.
The display shows i10 or i11.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain
the water.
The display shows i20.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows i30.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in the user
manual.
Malfunction of the water level
detection sensor.
The display shows i41 - i44.
• Make sure that the filters are clean.
• Switch the appliance off and on.
Malfunction of the wash pump
or the drain pump.
The display shows i51 - i59 or
i5A - i5F.
• Switch the appliance off and on.
The temperature of the water
inside the appliance is too high
or malfunction of the tempera-
ture sensor occurred.
The display shows i61 or i69.
• Make sure that the temperature of the inlet water does not ex-
ceed 60°C.
• Switch the appliance off and on.
17