Zanussi ZDS 689 EX, Инструкция пользователя

Страница: 7 / 36

Before using your dishwasher for the first time:
1. ensure that the electrical and water
connections comply with the installation
instructions
2. remove all packaging from inside the appliance
3. set the water softener
4. fill the salt container
5. fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the water
supply, which would have a detrimental or adverse
effect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.
Water hardness is measured in equivalent scales,
German, French degrees and PPM (parts per Million).
The softener should be adjusted according to the
hardness of the water in your area. Your local Water
Authority can advise you on the hardness of the water in
your area.
The dishwasher is factory set at level 4.
If this level is not suitable for your area the softener
should be adjusted.
To select a different level proceed as
follows:
- Press the On/Off pushbutton on.
- Press the "SELECTION" and "DELAY" buttons
simultaneously for about 2 seconds. "L4" appears in
the display which corresponds to the current level.
- Press the "DELAY" button as many times as
necessary until the required level appears in the
display. The level increases by 1 each time the button
is pressed.
- 5 seconds after this button has last been pressed, the
dishwasher memorises the level selected and returns
to the programme setting mode.
Before use
7
PBU06UK
SO239
Level
French
degrees
PPM
(Parts per Million)
German
degrees
0
1
2
3
4
5
6
7
8
9
0 - 4
5 - 8
9 - 11
12 - 17
18 - 22
23 - 28
29 - 33
34 - 39
40 - 45
46 - 50
0 - 8
9 - 14
15 - 20
21 - 30
31 - 40
41 - 50
51 - 60
61 - 70
71 - 80
81 - 90
0 - 80
81 - 140
141 - 200
201 - 300
301 - 400
401 - 500
501 - 600
601 - 700
701 - 800
801 - 900
Water hardness