Zanussi ZDN11002XA, Руководство пользователя

Страница: 14 / 72

Once you have checked the appliance, press . If
the problem occurs again, contact the Service.
For alarm codes not described in the table, contact
the Service.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem Possible solution
There are whitish streaks or blu-
ish layers on glasses and dishes.
• The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
• The quantity of detergent is too much.
There are stains and dry water
drops on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
The dishes are wet. • The programme does not have a drying phase or has a drying
phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Refer to "Hints and tips" for other
possible causes.
TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 446/818-898/576
Electrical connection
1)
Voltage (V) 220-240
Frequency (Hz) 50
Water supply pressure Min. / Max. bar (MPa) 0.5 (0.05) / 8 (0.8)
Water supply
Cold water or hot water
2)
max 60 °C
Capacity Place settings 9
Power consumption Left-on mode (W) 0.50
Power consumption Off-mode (W) 0.50
1) Refer to the rating plate for other values.
2) f the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
RATING PLATE
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
INFORMATION FOR TEST INSTITUTES
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on
the rating plate.
14