Zanussi ZDI22003XA, Руководство пользователя

Страница: 7 / 52

the programme selection mode, turn the appliance
off and on again or implement the CANCEL
procedure.
CANCEL PROCEDURE
Use CANCEL to:
• Cancel a currently running programme.
• Stop the countdown of
option.
• Bring the appliance back to the programme
selection mode.
To implement CANCEL:
Press and hold until the appliance is in the
programme selection mode.
USER MODE
Enter user mode to change the following appliance
settings:
• Adjust the level of the water softener according
to the water hardness.
• Activate or deactivate AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold
and simultaneously turn the
knob counterclockwise until the programme marker
is in
position.
The on/off indicator and start to flash.
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
ADJUSTING THE WATER SOFTENER
Make sure the programme marker points at the
on/off indicator.
1. Press and hold
and simultaneously turn the
knob counterclockwise until the programme
marker is in
position.
2. Release when the on/off indicator and
start to flash.
The intermittent flashing of the indicator shows
the current water softener setting (e.g. 5 f
pause + 5 flashes... = level 5).
3. Press
repeatedly to change the setting.
Each pressing of the button increases the
level number by one. After reaching level 10,
the count starts again from level 1.
4. Turn the knob back to the position of the on/off
indicator to confirm and save the setting.
THE WATER HARDNESS TABLE
German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke degrees
Water softener
level
47 -50 84 - 90 8.4 - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1
2)
1) Factory setting
2) Do not use salt at this level.
7