Downloaded from www.vandenborre.be
Warning! Deactivate the appliance before you make
the checks.
Problem
Possible cause
The programme does not
start.
The mains plug is not connected in the
mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
Cancel the delay start or wait for the end
The appliance does not fill
with water.
The water tap is closed.
The water pressure is too low.
Contact your local water authority.
The water tap is clogged or there is lime-
scale on it.
Clean the water tap.
The filter in the water inlet hose is clog-
ged.
Clean the filter.
The water inlet hose has a kink or a
bend.
Make sure that the position of the hose is
correct.
The anti-flood device is on. There are
water leakages in the appliance.
Close the water tap and contact the Serv-
ice.
The appliance does not drain
the water.
The sink spigot is clogged.
Clean the sink spigot.
The water drain hose has a kink or a
bend.
Make sure that the position of the hose is
correct.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Service.
If the display shows other alarm codes, contact the Serv-
ice.
The washing results and drying results are not satisfactory
Problem
Possible cause
Possible solution
The dishes are not clean.
The filters are clogged.
Clean the filters.
The filters are not correctly assembled
and installed.
Make sure that the filters are correctly as-
sembled and installed.
The spray arms are clogged.
Remove remaining soil with a thin pointed
object.
The programme was not applicable for
the type of load and soil.
Make sure that the programme is applica-
ble for the type of load and soil.
23
