Zanussi ZDF12001XA, Руководство пользователя

Страница: 7 / 12

20
30
A
B
3
20
30
4
Put the detergent or the tablet in compartment
(
A ) If the programme has a prewash phase,
put a small quantity of detergent in compart-
ment (
B ).
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the
rinse aid dispenser are full.
3. Start the shortest programme with a rins-
ing phase, without detergent and without
dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
start a programme.
Turn the programme knob until the programme
marker is aligned with a programme on the
control panel. If comes on and starts to
flash the appliance is in setting mode.
If the control panel does not show this condi-
tion, press and hold, at the same time
and
until the appliance is in setting mode
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker
is aligned with the symbol of the pro-
gramme you want to set.
•
comes on.
•
starts to flash.
4. Press to start the programme.
•
and are on.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance con-
tinues from the point of interruption.
Cancelling the programme
1. Press and hold
and until starts
to flash.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed
comes on. If you do not deactivate the appli-
ance within 5 minutes all indicators goes off.
This helps to decrease energy consumption.
1. To deactivate the appliance, turn the knob
until the programme marker is aligned with
.
2. Close the water tap.
7
www.zanussi.com