Zanussi ZDC68560W, Руководство пользователя

Страница: 14 / 20

What to do if ...
Troubleshooting by yourself
Problem
1)
Possible cause Remedy
Dryer does not
work.
Dryer not connected to mains supply.
Plug in at mains socket. Check fuse in fuse box
(domestic installation).
Loading door opened. Close loading door
The START PAUSE button not pressed. Press the START PAUSE button.
Unsatisfactory
drying results.
Incorrect programme set.
Set suitable programme.
2)
Fluff filters clogged.
Clean fluff filters.
3)
Heat exchanger clogged.
Clean heat exchanger.
3)
Max. loading exceeded. Respect max. loading volume.
Covered ventilation grill. Uncover ventilation grill in base area.
Residue inside the drum. Clean the drum inside.
High water hardness.
Set suitable water hardness
4)
.
Loading door
does not close
Filters not locked in place.
Install fine filter and/or snap course filter into
place.
Err
(
Error
) on
the LCD.
5)
Attempt to change parameters after start of the
programme.
Turn the dryer off and on. Set requested param-
eters.
No drum light
Programme selector in OFF position.
Turn it to DRUM LIGHT (if available) or to any
programme.
Defective light bulb. Replace light bulb (see next section).
Abnormally
elapsing time
on the LCD
5)
Time to end is calculated on the basis of: type,
volume and dampness of laundry.
Automatic process; this is not a machine fault.
Programme in-
active
Full water reservoir.
Empty water reservoir
3)
, press START PAUSE
button.
Drying cycle to
short
Small laundry volume./Too dry laundry for se-
lected programme.
Select time programme or higher drying level
(e.g. EXTRA DRY ).
Drying cycle to
long
6)
Fluff filters clogged. Clean fluff filters.
To high loading volume. Respect max. loading volume.
Laundry insufficiently spun. Spun adequately the laundry.
Particularly high room temperature - no ma-
chine fault.
Lower the room temperature if possible.
1) In case of error message on the LCD (e.g. E51 - only dryers with the LCD): Switch the dryer off and on. Set programme. Press the
START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see
Programme overview
chapter
3) see
Care and cleaning
chapter
4) see
Machine settings
chapter
14