17
Installation
Positioning
Place the refrigerator away from direct sunlight and
heat sources.
Maintain recommended ventilation - see Fig. 1.
Make sure the refrigerator is accurately levelled tur-
ning the adjustable feet in order to avoid vibrations
and noises Fig. 2.
This is a built in design to be aligned with other fur-
niture.
The appliance should be only set up at a location
whose ambient temperature corresponds to the cli-
mate classification, for which the appliance is desig-
ned.
The climate classification can be found on the serial
plate of the appliance.
The following table shows which ambient tempera-
ture is correct for each climate classification:
Climate classification
for an ambient temperature of
SN
+ 10 to + 32°C
N
+ 16 to + 32°C
ST
+ 18 to + 38°C
T
+ 18 to + 43°C
However, the manufacturer make sure the correct
operation of the appliance from minimum tempera-
ture of 10°C to upper limit of each climatic class.
Cleaning the interior
Do not use alcohol or any cleanig product containing
alcohol because it can damage the cabinet.
Before using the appliance for the first time wash the
interior whith luke warm water and some neutral
soap so as to remove the typical smell of a brand-
new product and then dry thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
Remove security used for transportation.
Electrical connection
m
Before plugging the appliance into a socket make
sure that the voltage and frequency shown on the
rating plate correspond to your home supply.
m
It is essential that the appliance be connected to an
efficient earth tap.
For this purpose the supply cable plug incorporates a
special earth contact. If the sockets of your domestic
Fig. 2
Fig. 1
wiring system are not grounded, have the
appliance connected to a separate ground wire in
accordance with existing safety regulations.
«THE MANUFACTURER DECLINES TO
ACCEPT ANY LIABILITY IF THIS SAFETY
RULE IS NOT OBSERVED».
Starting up
Plug the appliance into the mains.
Turn to intermediate position the knobs of the
«temperature regulators» «A» Fig. 5.
Make sure the inner light «H» turns on when
opening de door.
