Zanussi ZCOF636X, Инструкция

Страница: 5 / 24

4
FIRST USE
FILL THE WATER TANK
•
Water hardness :
- before filling the water tank make sure that the
Brita filter is in place (see paragraph "Water
supply").
- if the appliance has not been used for a long time
it is advisable to replace the water in the tank
with fresh water and to empty the boiler by
pressing the coffee button (ref.4) repeatedly.
•
Open the unit clamping lock (ref.24) using the
key supplied.
•
Pull the coffee machine out of the unit on the
telescopic runners.
•
Fill the water tank (ref.27) located on the left-
hand side of the appliance with approx. 2,5 litres
of water.
•
Push the machine back into the unit and fasten
the unit clamping lock.
FILL THE COFFEE BEAN HOLDER
•
Open the unit clamping lock (ref.24) using the
key supplied.
•
Pull the coffee machine out of the unit on the
telescopic runners.
•
Pour approx. 200g of coffee beans into the
coffee bean holder (ref.26) on the right-hand side
of the appliance.
•
Push the machine back into the unit and fasten
the unit clamping lock.
ADJUSTING THE TEXTURE OF
GROUND COFFEE
•
The machine is supplied already calibrated to
grind coffee beans to the ideal texture.
•
The texture of ground coffee can however be
adjusted using the grinding texture knob (ref.2).
Turn the knob clockwise for a finer texture and
stronger coffee. Turn anticlockwise for a coarser
grind and weaker coffee.
PROGRAMMING THE QUANTITY
OF GROUND COFFEE
•
The machine is supplied already calibrated
to supply the ideal measure of ground coffee
for a cup of espresso.
•
However, the quantity of ground coffee
supplied can be increased or decreased as
follows:
place the filter holder (ref.20) with a one-cup
filter (ref.21) below the coffee dispenser outlet
(ref.19) and press the grinder button (ref.18)
gently, do not release the button immediately.
After approx. 10 seconds the grinder will start,
when the quantity required is reached
(recommended measure 7g corresponding to 6
seconds of grinding) simply release the button
(ref.18) and the amount is automatically
programmed.
PRELIMINARY START-UP
•
Only move the steam spout using the rubber
handle.
•
Turn the coffee machine on by pressing the ON
button (ref.3). The orange indicator light (ref.8)
lights up to indicate that the machine is
connected to the power supply.
•
Turn the steam knob (ref.1) anti-clockwise.
•
Press the hot water button (ref.5) and wait until
all the air in the boiler is released through the
steam spout (ref.16) and water starts coming
through.
•
The red indicator light (ref.9) illuminates at the
same time to indicate that the water in the
boiler is being heated. When the red indicator