15
Changing the opening direction of
the door
Before buiding-in the appliance (if necessary),
change the opening direction of the door. To do this,
proceed as follows:
1. Remove the lower hinge (1) and feet (3)
2. Slide the door out from pin (G) and place it on the
opposite side;
3. Unscrew the foot front left and place it on the
opposite side;
4. Unscrew the two screws which mask the holes
for fixing the hinge on the front left side;
5. Reassemble the door
6. refit the lower hinge and feet (3) on the opposite
side;
7. dismantle the handle and reassemble it on the
opposite side.Cover the holes left open with the
plugs contained in the documentation pack.
Attention
After completion of the door reversibility
operation, verify that the door gasket is adherent
to the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
G
D590
D715
1
3
D162
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top corners.
Slacken the screws and insert the scraper under the
screw head, then re-tighten the screws.
D594
