Zanussi ZBT23420SA, Руководство пользователя

Страница: 19 / 48

Problem Possible cause Solution
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate of
the refrigerator.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
This is correct.
Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows into
the water collector.
Make sure that products do not touch
the rear plate.
Water flows on the ground. The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
Attach the melting water outlet to the
evaporative tray.
The temperature in the appliance
is too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
The temperature in the appliance
is too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
Many products are stored at the same
time.
Store less products at the same time.
There is no cold air circulation in the
appliance.
Make sure that there is cold air circula-
tion in the appliance.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
Remove the screw from
the lamp cover.
Remove the lamp cover
(refer to the illustration).
Replace the used lamp
with a new lamp of the
same power and specifi-
cally designed for house-
hold appliances (the maxi-
mum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the
lamp cover.
Connect the plug to the
mains socket.
Open the door. Make sure
that the light comes on.
19