26
www.zanussi.com
• The electrical outlet should be readily
accessible so that the unit can be unplugged
easily in an emergency. Or it should be
possible to isolate the oven from the supply
by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
• The socket should not be positioned behind
the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230-240 V/50 Hz alternating current via a
correctly installed earth socket.
• If the appliance is to be operated in a non-
European country, the supply voltage, current
type and frequency of the appliance indicated
on the rating plate must correspond with the
specification of your power supply. The rating
plate can be found on the inside face of the
control panel.
• The power supply cord may only be replaced
by an electrician.
• Before installing, tie a piece of string to the
power supply cord to facilitate connection to
point (A) when the appliance is being installed.
• When inserting the appliance into the high-
sided cupboard, DO NOT crush the power
supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.
(A)
9.3
Connecting the appliance to the power supply
9.2
Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500 mm (E) above the worktop and
must not be installed directly above a
hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and
microwave should be allowed to
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is
operating.
• Care should be taken when attending
to the microwave oven while the hob
is on.
Electrolux_EN240_CS_AG15_TINS-B109_Layout 1 12/03/2015 10:00 Page 26
