Zanussi ZBB 7266, Руководство пользователя

Страница: 10 / 16

Problem Possible cause Solution
There is too much frost and ice Products are not wrapped properly Wrap the products better
Doors are not shut properly or do not
close tightly
Check if the doors close well and the
gaskets are undamaged and clean
The Temperature Regulator may be set
incorrectly
Set a warmer temperature
It is too warm in the freezer Temperature Regulator may be set in-
correctly
Set a lower temperature
The door does not close tightly or it is
not shut properly
Check if the door closes well and the
gasket is undamaged and clean
Large quantities of food to be frozen
were put in at the same time
Insert smaller quantities of food to be
frozen at any one time.
Food placed in the appliance was too
warm
Allow food to cool to room temperature
before storing.
Products to be frozen are placed too
closely to each other
Place the products in a way so that cold
air could circulate among them
It is too cold inside the freezer Temperature Regulator may be set in-
correctly
Set a warmer temperature
The appliance does not work at
all. The appliance does not cool
at all. Neither cooling nor light-
ing works
The appliance may be switched off Switch on the appliance
Plug is not connected to the mains
socket properly
Connect the mains plug properly
Power does not reach the appliance Try connecting another electrical device
to the power outlet
There is no voltage in the mains sock-
et (try to connect another appliance in-
to it)
Call an electrician
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Press on the rear hook and at the same time slide the
cover in the direction of the arrow.
2. Replace the lamp with one of the same power and
specifically designed for household appliances. (the
maximum power is shown on the light bulb cover).
3. Install the lamp cover by fixing it into its original po-
sition.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
10