Problem
Possible cause
Solution
The lamp is defective.
Contact the nearest Authorised
Service Centre.
The compressor operates con-
tinually.
Temperature is set incorrect-
ly.
Refer to "Operation".
Many food products were
put in at the same time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on
the rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The "QuickChill" is switched
on.
Refer to "QuickChill ".
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
The water drainage plug is
not correctly positioned.
Position the water drainage plug
in the correct way.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrect-
ly.
Refer to "Operation" .
The compressor does not start
immediately after pressing the
"QuickChill", or after changing
the temperature.
This is normal, no error has
occurred.
The compressor starts after a pe-
riod of time.
Water flows on the rear plate
of the refrigerator.
During the automatic de-
frosting process, frost melts
on the rear plate.
This is correct.
Water flows inside the refriger-
ator.
Food products prevent the
water to flow into the water
collector.
Make sure that food products do
not touch the rear plate.
The water outlet is clogged.
Clean the water outlet.
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water outlet to
the evaporative tray.
8
