45
Changing the opening direction of
the doors
Before carrying out any operations, remove the plug
from the power socket.
To change the opening direction of the door, proceed
as follows:
1. pull off the ventilation grille (D) which is clipped into
place;
2. remove the hole cover (G) and the bottom hinge (E)
by unscrewing its three fixing screws;
3. remove the lower door, sliding it out of the middle
hinge;
4. unscrew the middle hinge (H);
5. remove the upper door, releasing it from the upper
pin (A);
6. unscrew the upper pin (A) and refit it on the opposite
side;
7. remove the two plugs of the door (where available),
discovering the holes for the hinge pins, assemble
them on the opposite side and refit the upper door;
8. reassemble the middle hinge on the opposite side;
9. using a 10 mm spanner, unscrew the hinge pin (E)
and reassemble it on the opposite side of the hinge;
10. reassemble the lower hinge (E) on the opposite
side, using the screws previously removed; insert
the hole cover (G) on the lower hinge. Slide the hole
cover (F) out of the ventilation grille (D) by pushing
it in the direction of the arrow and reassemble it on
the opposite side;
11. reassemble the lower door;
12. refit the ventilation grille (D), clipping it into place.
13. Unscrew the handles. Refit them on the opposite
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs supplied in
the documentation pack.
To line up the doors, it is possible to adjust the middle
hinge (H) horizontally by means of a tool, after
slackening the two screws (see figure).
Warning:
After having reversed the opening direction of the doors
check that all the screws are properly tightened and
that the magnetic seal adheres to the cabinet. If the
ambient temperature is cold (i.e. in Winter), the gasket
may not fit perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate this
process by heating up the part involved with a normal
hairdrier.
D736
A
PR24
H
F
D
PR18
F
F
F
E
E
G
D737
D594
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top
corners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
