37
Defrosting
Frost is automatically eliminated from the
evaporator of the refrigerator compartment every
time the motor compressor stops, during normal
use.
The defrost water drains out through a trough into
a special container at the back of the appliance, over
the motor compressor, where it evaporates.
It is important to periodically clean the defrost water
drain hole in the middle of the refrigerator compartment
channel to prevent the water overflowing and dripping
onto the food inside.
Use the special cleaner provided, which you will find
already inserted into the drain hole.
D037
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch
off the power supply or to remove the foodstuffs.
Never use sharp metal tools to scrape off frost from the
evaporator as you could damage it.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried
out as follows:
pull out the plug from the wall socket or turn the
thermostat knob to the «
O
» setting;
remove any stored food, wrap it in several layers of
newspaper and put it in a cool place;
leave the door open, place a basin on the top shelf of
the refrigerator compartment, under the drain hole,
lift the plug as shown in the figure;
when defrosting is completed, dry the interior
thoroughly and refit the plug;
keep the scraper for future use;
turn the thermostat knob back to the required
setting or replace the plug in the power socket.
After two or three hours, reload the previously
removed food into the compartment.
Important:
A temperature rise of the frozen food
packs, during defrosting, may shorten their safe
storage life.
D016
