Zanussi WJS 1397 W, Инструкция пользователя

Страница: 23 / 31

23
Symptom
The door will not open
n
The programme is still running (the door locked light is on).
n
The door lock has not yet released.
n
There is water in tub.
The machine makes an unusual
noise
n
The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor ensures a
softer start and more even distribution of the laundry in the drum when
spinning, as well as increased stability of the machine.
The machine does not dry or does
not dry properly
n
The drying time has not been selected
n
The water taps are not turned on
n
The drain filter is clogged
n
The machine is overloaded
n
The selected drying time or sector are not suitable for the laundry
If after the above checks, there is still a fault, call your
local Zanussi Service Force Centre.
Service & Spare Parts
If you require an engineer or wish to purchase spare
parts contact your local Zanussi Service Force Centre
by telephoning:
0870 5 929929
Your telephone call will be routed to the Service Centre
covering your post code area.
Further information can be found in the accompanying
customer care booklet and also in your telephone
directory under “Z”.
When you call the Service Force Centre please make
sure you give the model and serial number of the
appliance.
This information can be found on the rating plate (see
picture) or on the guarantee card.
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown. Please note that proof of
purchase is required for any in-guarantee service
calls.
Mod. ..........
Prod. No. ...........
Ser. No. .........
Mod.
..........
Ser.
P0042
Customer Care
For general enquiries concerning your Zanussi appliance
or for further information on Zanussi products, please
contact our Customer Care Department by letter or
telephone as follows:
Customer Care Department
Zanussi
55-77 High Street
Slough
Berkshire
SL1 1DZ
Tel 08705 727727
Possible causes
Spinning starts late or the machine
does not spin
n The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can resume.
If, after 10 minutes, the laundry is still not evenly distributed in the
drum, the machine will not spin. In this case, redistribute the load
manually and reselect the spin programme.
No water is visible in the drum
n
Machines based on modern technology operate very economically
using very little water without affecting performance.