ENGLISH
7
Installation
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
Using a spanner, unscrew and remove the rear right-
hand bolt and lay the machine on its back, taking
care not to squash the hoses. This can be avoided
by placing one of the corner packing pieces between
the machine and the floor.
Remove the polystyrene base and take off the
bottom panel by unscrewing the central screw.
Carefully slide out the right polythene bag.
Repeat the operation for the left and central
polythene bags.
Re-fit the bottom panel using the 4 screws supplied
with the door hinges (in the plastic bag) and the
previously removed screw.
Set the machine upright and remove the two
remaining bolts from the back.
P0453
P0016
P0015
P0457
P0255
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
Plug the open holes with the plugs which are
supplied with the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of use.
P0021
P1088
P1051
P0020
P0256
132987050.qxd 02/11/2004 09:49 Pagina 7
