Now you can set the programme.
After having set the programme, the display shows
the duration in hours and minutes (ex..
2.05
).
The time refers to the maximum load for each
programme.
The figures blink until the programme is started
pressing the START/PAUSE button.
After the start, the indication of the remaining time
decreases by one unit every minute.
Many elements determine the duration of the
programme, e.g. the wash load, the temperature of
the incoming water, the formation of lather, etc.
These elements are recorded by the electronic
system and the indication of the remaining time is
updated accordingly.
The end of the programme is shown on the display
with a blinking zero.
The delayed start that was set with the button (11) is
shown on the display (max 24 hours).
The delay time value will decrease by one unit every
hour.
Delayed start
Duration
The selected drying time is displayed in minutes or
hours and minutes.
After starting the programme, the remaining time is
updated every minute.
If an option which is not compatible with the set wash
programme is selected, the message
Err
is
displayed.
This is also indicated by three sound signals and by
the corresponding lights that blink for about 2
seconds.
In case of breakdowns of the appliance, these are
indicated on the display with a special code, very
useful for the user and for the technical assistance,
e.g.
“E20”
(see pages 29-30).
Alarm code
Incorrect option selection
Drying time
14
132998780•gb.qxd 15-02-2001 12:22 Pagina 14
