Zanussi U33109 ZDE 26000 W, Инструкция пользователя

Страница: 18 / 24

18
Once connected to
the dryer, run the vent
hose to the desired
outlet point, ensuring
that the run’s overall
length is less than 2
m, and that it
contains no more
than two bends. As to the outlet itself, if
you have decided on a fixed
wall/window grille, a good local builder’s
merchant should be able to supply you
with the necessary fittings and
installation advice.
Important:
It is important not to
connect the vent
hose to, for example,
a cooker hood, or a
chimney or flue pipe
designed to carry the
exhaust from a fuel
burning appliance.
Note that to avoid condensation
problems, it is essential that the dryer be
fitted with the flexible hose to carry its
“exhaust” at least beyond the kitchen
units; preferable outside the kitchen. In
order to prevent the appliance from
overheating, it is important that the
steam exhaust is unobstructed.
Therefore, in case of a permanent hose
fitted to an exterior wall or ceiling, it must
be ensured an exhaust capacity of at
least 150 m3/h. If the dryer is fitted next
to kitchen units, make sure that the vent
hose is not squashed. If the hose is
partially squashed, drying efficiency will
be reduced, resulting in longer drying
times and higher energy consumption. If
the hose is completely squashed, the
safety cut-outs with which the machine
is fitted may operate. When operating
the tumble dryer, the room temperature
must not be lower than +5°C and higher
than +35°C, as it may affect the
performance of the appliance.
Electrical connection
This machine is designed to operate on
a 230-240 V, single-phase, 50 Hz
supply. Check that your domestic
electrical installation can take the
maximum load required (2.25 kW), also
taking into account any other appliances
in use.
Connect the machine to an earthed
socket, in accordance with current wiring
regulations.
Important:
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution. Should the
appliance power supply cable need to
be replaced, this must be carried out
by our Service Centre.
Important:
The power supply cable must be
accessible after installing the
machine.
Stacking kit
A special stacking kit is available through
your dealer, to enable the mounting of
the dyer on top of a front loading
washing machine with cover’s depth
between 48 and 60 cm.
Read carefully the instructions supplied
with the kit.
055
056
B