6
Hob burners
To light a burner:
- turn the relevant control knob anticlockwise to
maximum position.
- At the same time push the electric ignition button
which is marked with a little spark.
- Then adjust the flame as required.
If the burner does not ignite, turn the control knob to
zero, and try again.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
If you use a saucepan which is smaller than the
recommended size, the flame will spread beyond
the bottom of the pan, causing the handle to
overheat.
Controls
F
Before the First Use of the Cooker
Remove
all packaging
, both inside and outside
the cooker,
before using it.
Before first use, the oven should be heated without food.
During this time, an unpleasant odour may be emitted.
This is quite normal.
1. Set the electronic timer to manual function.
2. Switch the oven function control knob to fan cooking
.
3. Set the thermostat control knob to MAX.
4. Open a window for ventilation.
5. Allow the oven to run empty for approximately 45
minutes.
This procedure should be repeated with the grill
function for approximately 5-10 minutes.
INSTALLATION
Any gas installation must be carried out by a
CORGI registered installer, and in accordance with
existing rules and regulations.
The relevant instructions are to be found in the second
section of this manual.
Please ensure that when the appliance is installed, it is
easily accessible for the engineer in the event of a
breakdown.
WHEN THE COOKER IS FIRST INSTALLED
Once the cooker has been installed, it is important
to remove any protective materials, which were
put on in the factory.
