Zanussi ER 7831 I, Инструкция по установке и эксплуатации

Страница: 8 / 19

Position the runners (A) at the top and bottom
of the inside of the kitchen unit as shown in Fig.
9 and mark the position of the external holes.
After preparing the holes, screw the runners to
the kitchen unit door using 3.5x16 mm screws.
Open both the appliance door and that of the
kitchen unit to approx. 90°.
Place the little plates over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little plates
over the runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
If the appliance is fixed to the side of the kitchen
unit, simply slacken the screws in fixing
brackets (D), move the brackets as shown in
the figure and re-tighten the screws.
Then fit cover (E).
PR33
20mm
A
8mm
PR34
PR35
D
E
D734
Fig. 9
Fig. 10
Fig. 11
Fig. 12
8