Zanussi DWS 909 Скачать руководство пользователя страница 9

Страница: 9 / 16

Before using your dishwasher for the
first time:

1. Ensure that the electrical and water connections comply

with the installation instructions

2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and then fill

with salt

5. Fill the rinse aid dispenser.
6. Run a "Rinse and Hold" programme.

Setting the water softener

The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, Clarke,
French degrees and PPM (parts per Million).
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener should be
adjusted.
If your water is level 0 it is already soft and therefore
there is no need to use salt.
In this case adjust the water softener on level 1 without
using salt.

Only for dishwasher models with salt refill
indicator light:

if the water softener has been adjusted on level 1 without use
of salt, the salt refill indicator light on the control panel will
always remain illuminated when the machine is switched on.

To adjust the water softener

With a screwdriver turn the selector on the upper front corner
of the machine until the level
required corresponds with the
marker.

Filling with salt

Attention!
Only use salt specifically designed for use in
dishwashers.
All other types of salt not specifically designed for use in
dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting a washing
programme. This will prevent any grains of salt or salty
water, which may have been spilled, remaining on the
bottom of the machine, which may cause corrosion.

To fill:

To fill with salt,

unscrew the cap of the salt container.

2. Pour 1 litre of water inside the container (this is necessary

only before filling with salt for the first time).

3. Using the funnel (if

provided), pour in the salt
until the container is full.
Do not worry if water over
flows from the unit when
filling with salt, this is quite
normal.

4. Replace the cap making

sure that there is no trace
of salt on the screw thread
or on the gasket.

5. Screw on the cap tightly.

The salt container will require topping up periodically.
According to the model, an indicator reminds you when filling
with salt:

A) The salt cap has a refill

indicator window in the centre.
A green float is clearly
visible when there is salt
inside the container, and
almost disappears when the
salt has finished reminding
you to add salt.

B) A salt indicator light on the

control panel will come on
when the salt has finished.

The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer.
The function of the machine is not affected..

Before use

Level

Use of

salt

French

degrees

(°TH)

PPM

(Parts per

Million)

Clarke

degrees