6
3.6. Action during a programme
3.6.1. Adding of laundry
Press the Start/Pause pushbutton : the corresponding
light flashes as long as the programme is paused. You
will then hear a double "click" in the locking device
when the cover opens. Press the same pushbutton
again to resume the programme.
For reasons of safety, you cannot open the cover if the
temperature of the washing water is too high.
3.6.2. Modifying the current programme
Before modifying the options of the current programme,
you must put the washing machine to pause by pres-
sing on the «Start/Pause» pushbutton. If it is impossible
to make the modification, the corresponding light
flashes for few seconds.
If you decide to change the programme in any case,
you will need to cancel the current programme (see be-
low).
3.6.3. Cancelling the programme
If you want to cancel a programme, turn the programme
selector knob to the «off» position of the programme
selector.
You can then select a new programme.
3.7. End of programme
The washing machine stops automatically. You will
hear a double "click" in the locking device when the
cover opens. The cycle end light goes on.
If you choose the rinse hold position*, the rinse hold li-
ght* illuminates to inform you that water has to be drai-
ned before you can open the cover. To terminate the
cycle, you can then spin the washing by choosing the
spinning programme or drain it by choosing the drai-
ning programme.
Turn the programme selector knob to the "Off" position.
Take out the laundry.
Pull out the power supply plug and close the water sup-
ply tap.
Note:
we recommend that you should leave the cover
and the drum open after use to air the washing drum.
*depending on model
