37
Connecting the dishwasher
Connecting to the water
supply
•
The dishwasher can be connected to cold or hot
water supplies up to max. 60°C.
•
The dishwasher must not be connected to open
hot water appliances or instantaneous water heat-
ers.
Permitted water pressure
Connecting the inlet hose
1
The water inlet hose must not be kinked,
crushed or entangled when it is being con-
nected.
Connect the threaded hose fitting (ISO 228-1:2000)
on the water inlet hose to a tap with an external
thread (¾ inch). The inlet hose is fitted with either a
plastic or a metal nut:
–
Only
tighten the nut
hand tight
.
Then do a visual check for water tightness. (Make
sure that the tap is not dripping.)
3
So that access to the tap in the kitchen is not
restricted by the use of the dishwasher, we
recommend installing an additional tap, or fit-
ting a T-branch to the existing tap.
If you need a longer water inlet hose than that sup-
plied, the following VDE-approved complete hose
sets are to be used. These are available from your lo-
cal Service Force.
Water drainage
Drain hose
1
The drain hose must not be kinked, crushed or
entangled.
Connecting the drain hose:
–
Maximum permitted height: 1 metre.
–
Minimum required height: 40 cm above the bot-
tom edge of the appliance.
Lowest permitted water pressure:
1 bar (=10 N/cm2 =100 kPa)
Consult your plumber if the water pressure is less than
1 bar.
Highest permitted water pressure:
10 bar (=100 N/cm2 =1 MPa)
If the water pressure is greater than 10 bar, a pressure
reduction valve must be used (available from your
dealer).
Содержание ZSF 6171
Страница 1: ...Dishwasher ZSF 6171 User information g ...
Страница 42: ...42 ...