17
Door Reversal
Disconnect the appliance from the electricity
supply.
Tilt back the appliance carefully. It is recommended
to ask another person for help, who can keep the
appliance at this position safely.
Unscrew on the both sides adjustable feet (2
pieces) and the fixing screws (2 pieces) of bottom
door holder and the far side screws (2 pieces) too.
Take off the door of the refrigerator by pulling it
slightly downwards.
Dismount the double door holder by removing the
screws (2 pieces).
Take off the door of the freezer by pulling it slightly
downwards.
Unscrew the top door holding pin of the freezer,
then screw it back on the other side.
Remove the covering nails of the double door
holder on the left side and put them to the other
side.
Fit the door of the freezer to the top door holding
pin.
Fix the double door holder onto the left side using
the screws (2 pieces). Be careful that the door
edge of the freezer is parallel with the edge of the
mantle.
Fit the door of the refrigerator to the double door
holding pin.
Fix the bottom door holder onto the left side using
the screws (2 pieces) and the adjustable foot as
well as screw the 2 pieces screws on the opposite
side into the vacant holes. Be careful that the door
edge of the refrigerator is parallel with the edge of
the mantle.
Put over the handle on the opposite side and cover
up the vacant holes with the plastic nails from the
bag of instruction book.
After released the screws the adaptation of the
doors can be adjusted with the horizontal control of
central door holder.
Put the appliance to its place, set it level and
connect to the electricity supply.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating the part involved with a normal
hairdryer on a low setting.
