Zanussi Electrolux ZRB 2725 W, Инструкция пользователя

Страница: 4 / 20

OPERATION
Before using
Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).
Setting the temperature
The temperature within the appliance is controlled by
the thermostat situated at the top of the appliance.
To operate the appliance proceed as follows:
Turn the thermostat control beyond the «0» position.
Setting “1”: Hightest temperature, (warmest setting).
Setting “6” (end-stop) : Lowest temperature, (coldest
setting).
Turn the thermostat control knob to the required
position.
The intermediate position is usually the most
suitable.
The thermostat control regulates the temperature
both within the fridge and the freezer compartment.
The thermostat setting can vary as the temperature
inside the appliance depends on the following
factors:
– room temperature
– how often the door is opened
– how much food is stored
– position of the appliance
Control panel
Do not use soap or detergent as the smell may
linger. Dry thoroughly.
Use of an air circulation slider
control - COOL FLOW CONTROL
Your appliance has an air circulation slider control
situated at the rear of the fridge compartment, which
controls the amount of cold air circulated through the
fridge compartment.
When the ambient temperature is between 10°C and
16°C, the slider control should be in the “MIN”
position.
When the ambient temperature is above 16°C the
slider control should be midway between “MIN” and
“MAX”.
When the ambient temperature is very high (i.e. hot
summer days) position the slider control to “MAX”.
D757/1
MIN MAX
COOL FLOW CONTROL
MIN MAX
COOL FLOW CONTROL
0
5
6
4
2
1
3
0
5
6
4
2
1
3
A - Pilot light
B - Thermostat control knob
To Start the Appliance
Allow the appliance to stand for 2 hours after
installation.
Plug in the appliance and switch on at the mains
supply. Turn the thermostat control (B) to a midway
setting and adjust the slider control, situated on the
back wall of the fridge section, to a midway position.
The pilot light (A) will illuminate. Leave the appliance
for approximately 4 hours for the correct temperature
to be reached before placing food inside.
To switch off the appliance turn the thermostat
control to position “0”
4