Zanussi Electrolux ZCM 651, Инструкция пользователя

Страница: 32 / 36

32
LEVELLING FEET
PENCIL LINE ON THE FLOOR
PLAN VIEW OF THE COOKER
580 mm.
100 mm.
300 mm.
295 mm.
WALL FACE
A
BACK OF COOKER
SIDE VIEW
OF THE COOKER
BASE OF COOKER
ENGAGEMENT EDGE FOR
STABILITY BRACKET
Fig. 3
Fitting the Stability Bracket
(Not supplied)
If the cooker has to be installed with a flexible supply
pipe, it is necessary that a stability device is fitted.
(See "Important Safety Requirements").
The stability bracket should be fitted by the installer and
these instructions should be read in conjunction with
the leaflet packed with the stability bracket.
Place cooker in its intended position and level cooker.
Mark off 295mm (11 1 /
2
") from the right hand side of the
cooker as shown, this is the centre line of the bracket
fixing.
Draw a line 100mm (4") from the front edge of the levelling
feet (see Fig. 1) and remove cooker from its position.
Mark off 580mm (23") back from this line on the centre
line of the bracket to locate the front edge of the lower
bracket.
Fix lower bracket (with two fixing holes) to the floor, then
measure height from floor level to engagement edge on
back of cooker, dimension 'A' of Fig. 2.
Assemble upper bracket to lower bracket so that
underside of bracket is dimension 'A' +3mm (1/8") above
floor level. Re-position cooker and check that top bracket
engages into cooker back to a depth of 75mm (3"), as
shown in Fig. 2.
Should the stability bracket currently installed not allow
the cooker to stand correctly, ask the installer to replace
it with the correct type.
Fig. 2
Connecting to Gas
This cooker is designed to be installed with an appliance
flexible connection. Connection is made to the RC 1/2
(1/2" B.S.P.) threaded entry pipe located just below the
hotplate level on the rear right-hand side of the cooker.
Check for gas soundness after connecting the gas supply.
The gas bayonet connector must be fitted in the shaded
area indicated in Fig. 3. Take into account that it must
be possible to pull the cooker forward sufficiently. The
hose must not get caught on the stability bracket.
Note:
If using different types of gas bayonet connection, it may
not be possible for the appliance to be pushed fully back
to the wall stops.
Important:
Flexible tubing MUST comply with BS.669 Current
Edition.
FO 0179
FO 0180
600
450
130