7
Operating Sequence
Before using your tumble dryer for the first time, we
recommend you place a few damp cloths inside the
appliance and dry for 20 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Press the ON/OFF button
: the mains-ON light
comes on.
6. Select the drying time.
7. If required, press the low temperature button
or the Cool Tumble button
.
8. Press the Start button
: the machine starts
operating .
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (position
on selector dial).
The machine stops automatically at the end of this
phase.
9. Release the ON/OFF button (the mains-ON light
goes out) and immediately remove the laundry.
P1108
P1149
After each use
• Switch the appliance off by releasing the ON/OFF
button
. The mains-ON light goes out.
• Clean the filters (see page 9).
• Empty the water reservoir (see page 10).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
(cooling) and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance.
Modifying the programme
To change a programme which is running without
opening the door, first depress the ON/OFF button
and then turn the time selector dial to the required
time. Press the ON/OFF button again.
125981552.qxp 2005-11-14 08:54 Page 7
